Product name: Motherboard MKS GEN V1.4
MKS GEN V1.4 uses Arduino Mega2560 chipset and is Ramps1.4 compatible. MKS GEN is a feature rich all-in-one electronics solution for 3D printers. It use FTDI FT232R device for USB and not ATMEGA16U2 as MEGA2560 for ARDUINO. The board can use the same firmware as Ramps1.4. MKS GEN is designed to be flexible in the user's power source availability, allowing any power supply from 12V-24V.
It is suitable for dual-Extrude printer
Easy DISPLAY + SD-CARD connector, RepRapDiscount SmartController compatible pin header on board
3x temperature ADC connectors for thermistors
Up to 5 motor drivers with A4982
4x PWM capable power mosfet outputs with voltage selector for MainPower.(Bed, Extruder0, Extruder1, Fans)
4 layers PCB, optimize heat dissipation.
6x end stop connectors with power supply Xmin/Xmax/Ymin/Ymax/Zmin/Zmax
Recoverable fuse for short-circuit protection.
USB Driver Chip FT232RL, you can get files from ftdichip to setup driver: Ftdi-x86.zip
Motherboard MKS GEN V1.4*1(dont contain the DRV8825)