3D Printer Kit MKS Base V1.4 3D Printer Controller Board With Mega 2560 R3 Motherboard RepRap Ramps1.4 + 12864 LCD Controller
For LCD 12864 Smart Controller, it contains a SD-Card reader. You can easily connect it to your Ramps board using the "smart adapter" included. After connecting this panel to your Ramps you don't need your PC any more, the Smart Controller supplies power for your SD card.
MKS Base V1.4 board:
This is the combination of Arduino MEGA2560 + RAMPS1.4 + 5 x A4982 drivers (remix board)
Arduino MEGA compatible Atmega2560 and FT232 processors are compatible with all RAMPS class firmware
Firmware can use the same configuration as RAMPS1.4
It is suitable for dual-Extrude printer
Easy DISPLAY + SD-CARD connector, RepRapDiscount SmartController compatible pin header on board
3x temperature ADC connectors for thermistors
Up to 5 motor drivers with A4982
4x PWM capable power mosfet outputs with voltage selector for MainPower.(Bed, Extruder0, Extruder1, Fans)
4 layers PCB, optimize heat dissipation.
6x end stop connectors with power supply Xmin/Xmax/Ymin/Ymax/Zmin/Zmax
Recoverable fuse for short-circuit protection.
USB Driver Chip FT232RL, you can get files from ftdichip to setup driver: Ftdi-x86.zip
12864 LCD Controller Board:
100% Brand new and high quality
Using a large screen 12864LCD(3.2'), it can support 8 GB
Integrated SD card back after slicing the file into the SD card on the LCD to select the corresponding file can be printed
Product comes encoder parameter adjustment can be achieved, and the file selection print
Ramps plug and play on, but the need to modify the firmware to support
1x MKS Base V1.4 3D Printer Controller Board
1x 12864 LCD Controller Board