TEVO 3D Printer parts MKS Base V1.4 3D Printer Control Board Ramps1.4 Compatible
1.Arduino MEGA compatible Atmega2560 and FT232 processors are compatible with all RAMPS class firmware
2.Firmware can use the same configuration as ramps1.4
3.Easy DISPLAY + SD-CARD connector,RepRapDiscount SmartController compatible pin header on board
4.Easy connect MKS TFT on AUX-1
5.3x temperature ADC connectors for thermistors
6.up to 5 motor driver with A4982
7.4x PWM capable power mosfet outputs with voltage selector for MainPower.(Bed,Extruder0,Extruder1, Fans)
8.4 layers PCB, optimize heat dissipation.
9.6x end stop connectors with power supply Xmin/Xmax/Ymin/Ymax/Zmin/Zmax
10.Recoverable fuse for short-circuit protection.
Packing list:
Motherboard MKS base V1.4*1
UBS Cable*1
2.Firmware can use the same configuration as ramps1.4
3.Easy DISPLAY + SD-CARD connector,RepRapDiscount SmartController compatible pin header on board
4.Easy connect MKS TFT on AUX-1
5.3x temperature ADC connectors for thermistors
6.up to 5 motor driver with A4982
7.4x PWM capable power mosfet outputs with voltage selector for MainPower.(Bed,Extruder0,Extruder1, Fans)
8.4 layers PCB, optimize heat dissipation.
9.6x end stop connectors with power supply Xmin/Xmax/Ymin/Ymax/Zmin/Zmax
10.Recoverable fuse for short-circuit protection.
Packing list:
Motherboard MKS base V1.4*1
UBS Cable*1
Questions & Answers
Ask a Question-
Does this come with preinstalled firmware???
Hi
Yes this comes with preinstalled firmware.
